Skip to main content

ASU Electronic Theses and Dissertations


This collection includes most of the ASU Theses and Dissertations from 2011 to present. ASU Theses and Dissertations are available in downloadable PDF format; however, a small percentage of items are under embargo. Information about the dissertations/theses includes degree information, committee members, an abstract, supporting data or media.

In addition to the electronic theses found in the ASU Digital Repository, ASU Theses and Dissertations can be found in the ASU Library Catalog.

Dissertations and Theses granted by Arizona State University are archived and made available through a joint effort of the ASU Graduate College and the ASU Libraries. For more information or questions about this collection contact or visit the Digital Repository ETD Library Guide or contact the ASU Graduate College at gradformat@asu.edu.


Contributor
Date Range
2010 2018


As integrated technologies are scaling down, there is an increasing trend in the process,voltage and temperature (PVT) variations of highly integrated RF systems. Accounting for these variations during the design phase requires tremendous amount of time for prediction of RF performance and optimizing it accordingly. Thus, there is an increasing gap between the need to relax the RF performance requirements at the design phase for rapid development and the need to provide high performance and low cost RF circuits that function with PVT variations. No matter how care- fully designed, RF integrated circuits (ICs) manufactured with advanced technology nodes necessitate ...

Contributors
Shafiee, Maryam, Ozev, Sule, Diaz, Rodolfo, et al.
Created Date
2018

The increased adoption of Internet-of-Things (IoT) for various applications like smart home, industrial automation, connected vehicles, medical instrumentation, etc. has resulted in a large scale distributed network of sensors, accompanied by their power supply regulator modules, control and data transfer circuitry. Depending on the application, the sensor location can be virtually anywhere and therefore they are typically powered by a localized battery. To ensure long battery-life without replacement, the power consumption of the sensor nodes, the supply regulator and, control and data transmission unit, needs to be very low. Reduction in power consumption in the sensor, control and data transmission ...

Contributors
Magod Ramakrishna, Raveesh, Bakkaloglu, Bertan, Garrity, Douglas, et al.
Created Date
2018

In this dissertation a new wideband circular HIS is proposed. The circular periodicity made it possible to illuminate the surface with a cylindrical TEMz wave and; a novel technique is utilized to make it wideband. Two models are developed to analyze the reflection characteristics of the proposed HIS. The circularly symmetric high impedance surface is used as a ground plane for the design of a low-profile loop and spiral radiating elements. It is shown that a HIS with circular periodicity provides a wider operational bandwidth for curvilinear radiating elements such, such as loops and spirals, compared to canonical rectangular HISs. ...

Contributors
Amiri, Mikal Askarian, Balanis, Constantine A, Aberle, James T, et al.
Created Date
2018

VCO as a ubiquitous circuit in many systems is highly demanding for the phase noises. Lowering the noise migrated from the power supply has been the trending topics for many years. Considering the Ring Oscillator(RO) based VCO is more sensitive to the supply noise, it is more significant to find out a useful technique to reduce the supply noise. Among the conventional supply noise reduction techniques such as filtering, channel length adjusting for the transistors, and the current noise mutual canceling, the new feature of the 28nm UTBB-FD-SOI process launched by the ST semiconductor offered a new method to reduce ...

Contributors
Tang, Miao, Barnaby, Hugh, Bakkaloglu, Bertan, et al.
Created Date
2018

Portable devices often require multiple power management IC (PMIC) to power different sub-modules, Li-ion batteries are well suited for portable devices because of its small size, high energy density and long life cycle. Since Li-ion battery is the major power source for portable device, fast and high-efficiency battery charging solution has become a major requirement in portable device application. In the first part of dissertation, a high performance Li-ion switching battery charger is proposed. Cascaded two loop (CTL) control architecture is used for seamless CC-CV transition, time based technique is utilized to minimize controller area and power consumption. Time domain ...

Contributors
Lim, Chai Yong, Kiaei, Sayfe, Bakkaloglu, Bertan, et al.
Created Date
2018

This work is concerned with the use of shielded loop antennas to measure permittivity as a low-cost alternative to expensive probe-based systems for biological tissues and surrogates. Beginning with the development of a model for simulation, the shielded loop was characterized. Following the simulations, the shielded loop was tested in free space and while holding a cup of water. The results were then compared. Because the physical measurements and the simulation results did not line up, simulation results were forgone. The shielded loop antenna was then used to measure a set of NaCl saline solutions with varying molarities. This measurement ...

Contributors
Yiin, Nathan, Aberle, James, Bakkaloglu, Bertan, et al.
Created Date
2018

The increase in computing power has simultaneously increased the demand for input/output (I/O) bandwidth. Unfortunately, the speed of I/O and memory interconnects have not kept pace. Thus, processor-based systems are I/O and interconnect limited. The memory aggregated bandwidth is not scaling fast enough to keep up with increasing bandwidth demands. The term "memory wall" has been coined to describe this phenomenon. A new memory bus concept that has the potential to push double data rate (DDR) memory speed to 30 Gbit/s is presented. We propose to map the conventional DDR bus to a microwave link using a multicarrier frequency division ...

Contributors
Bensalem, Brahim, Aberle, James T., Bakkaloglu, Bertan, et al.
Created Date
2018

Point of Load (PoL) converters are important components to the power distribution system in computer power supplies as well as automotive, space, nuclear, and medical electronics. These converters often require high output current capability, low form factor, and high conversion ratios (step-down) without sacrificing converter efficiency. This work presents hybrid silicon/gallium nitride (CMOS/GaN) power converter architectures as a solution for high-current, small form-factor PoL converters. The presented topologies use discrete GaN power devices and CMOS integrated drivers and controller loop. The presented power converters operate in the tens of MHz range to reduce the form factor by reducing the size ...

Contributors
Hegde, Ashwath, Kitchen, Jennifer, Bakkaloglu, Bertan, et al.
Created Date
2018

In this work, the development of a novel and a truly in-shoe force measurement system is reported. The device consists of a shoe insole with six thin film piezoresistive sensors and the main circuit board. The piezoresistive sensors are used for the measurement of plantar pressure during daily human activities. The motion sensor mounted on the main circuit board captures kinematic data. In addition, the main circuit board is responsible for the wireless transmission of the data from all the sensors in real-time using BLE protocol. It is housed within the midsole of the shoe, under the medial arch of ...

Contributors
Badarinath, Abhishek, Kiaei, Sayfe, Bakkaloglu, Bertan, et al.
Created Date
2018

Performance failure due to aging is an increasing concern for RF circuits. While most aging studies are focused on the concept of mean-time-to-failure, for analog circuits, aging results in continuous degradation in performance before it causes catastrophic failures. In this regard, the lifetime of RF/analog circuits, which is defined as the point where at least one specification fails, is not just determined by aging at the device level, but also by the slack in the specifications, process variations, and the stress conditions on the devices. In this dissertation, firstly, a methodology for analyzing the performance degradation of RF circuits caused ...

Contributors
Chang, Doo Hwang, Ozev, Sule, Bakkaloglu, Bertan, et al.
Created Date
2017